Small Snowy Surfaces from TauOnline.Org

Home >> Scenery >> Small Snowy Surfaces >> Printer-Friendly Version

Normal version

Thanks to Blayne Steed King for this.

To make the above snow piece, you will need the following scener pieces:

Cutting knife
Pink foam
Protective Seal Spray. Baking Soda
ROSS All Purpose dry clear glue
Smelly primer
Space wolves grey
Regal blue
Super spray 77 (will not melt foam)

Step 1

Using the cutting knife I carved the two pieces of pink foam to fit together on one side.

Step 2

After the pink foam was carved I then applyed them together using ROSS All Purpose dry clear glue.

Step 3

When the glue had dried I used a paint brush to uncoat the entire piece using regal blue.

Step 4

For the areas that I wanted to look higher in altitude I used smelly primer overlayers of space wolves grey.

Step 5

To add the snow texture I wanted on the piece I used a foam sprey adhesive over the areas I wanted to be flocked with a snow surface.

Step 6

Adding some baking soda over the sprayed areas of the pink foam I flocked it on with slightly heavy coats.

Step 7

Make sure you have covered the entire pink foam piece with layers of paint or the spray will melt through the pink foam. Now that that is done use a protective spray sealer to have the baking soda stay put. I would do this project outside or in a spray booth. I always try to wear a dust mask to protect myself from the particulants.